Nokia HA-0236G-A Product Manual page 36

ChapterTitleVariable
36
If the Ethernet backhaul is connected, the LED does not indicate the WiFi backhaul signal
quality. Only when the LED is blue-green, the extender indicates a good backhaul connection
and it has started and configured. At this time, you can remove the Ethernet backhaul cable
and it will switch to WiFi backhaul automatically, then you can move the extender to another
place.
Note 1 — You may consider repositioning the HA-0236G-A extender
after evaluating the WiFi backhaul signal. If :
•
there is no WiFi backhaul signal is weak or medium. The LED is solid
red or yellow.
•
you want to further improve your service.
You might need to repeat this cycle several times before finding the
best location for the HA-0236G-A extender.
Note 2 — Position the HA-0236G-A extender in a place with few
obstructions for Wi-Fi waves, least number of walls between the extender
and the RGW or any other extenders. Away from the metal fixture,
enclosures, cabinets, appliances, blinds, reinforced concrete, and pipes.
7 If necessary, reset the HA-0236G-A extender.
Note — Resetting the device will return all settings to factory default
values; any configuration customization will be lost.
i Locate the Reset button as shown in Figure 3.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button and push for more than 10 seconds to reset the device.
8 STOP. This procedure is complete.
3FE-48251-AAAA-TCZZA
Nokia WiFi HA-0236G-A Extender Product Guide
Issue 01