Nokia 7368 ISAM CPE A-240Z-A Product Manual page 58

Replace an A-240Z-A CPE
9
10
11
12
13
14
15
56
All manuals and user guides at all-guides.com
Connect the power cable to the power connector.
If applicable, install the power supply according to manufacturer specifications.
Note —
Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
Power up the unit by using the power switch.
Verify the CPE LEDs and voltage status; see the 7368 Hardware and Cabling Installation
Guide.
Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
If necessary, reset the CPE.
i Locate the Reset button on an A-240Z-A CPE as shown in Figure 14.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the CPE.
STOP. This procedure is complete.
3FE-46615-AAAA-TCZZA
7368 ISAM CPE A-240Z-A Product Guide
Issue: 01