PowerXL CM-001 Owner's Manual page 9

Using the Accessories
Rotisserie Spit Assembly
1. Insert each Skewer point through holes on the left
Skewer Rack (FIG. C).
2. Squeeze the clip end of each Skewer as you insert into
the opposite Skewer Rack slot to secure.
3. Release clip to securely rest in slot as shown
(FIG. D).
FIG. C - LEFT SIDE
Placing Rotisserie Spit or Rotating
Mesh Basket into Appliance
1. Insert the left side of the assembled Spit or Basket first into
the Rotisserie Shaft socket. Be sure the Rotisserie Shaft is in
place to engage rotation (FIG. E).
2. Place the right side onto the hanger (FIG. F).
Removing Rotisserie Spit
or Rotating Basket from Appliance
1. Open appliance door to pause cooking cycle or turn
appliance off by pressing the Power Button.
2. Insert Rotisserie Fetch Tool beneath the Rotisserie Shaft.
3. Using the Rotisserie Fetch Tool, lift the right side of the
Shaft at a slight angle to clear the bracket. Then, shift to
the right until the left side of the shaft slides out of the
Rotisserie Shaft socket.
4. Carefully remove the rotisserie food from the appliance.
5. Place food on a plate, cutting board, or the Rotisserie
Stand to remove food from the Shaft, Spit, or Basket.
4. Repeat steps 3–6 in a uniform manner around the Skewer
5. Ensure the Skewer Racks are inside the indentations on
6. Use caution while inserting the Shaft into the appliance.
FINAL ASSEMBLY
Rack. Make sure Skewers are evenly spaced.
the Shaft, tighten the Set Screws and ensure they are
securely in place.
The Skewer ends are sharp and can poke you.
IMPORTANT: See the Final Assembly diagram (page 8) to help identify
the left and right sides of the Rotisserie Shaft before placing it in
the appliance. The right side has two notches, and the left has one.
FIG. D - RIGHT SIDE
FIG. E - LEFT SIDE
FIG. F - RIGHT SIDE
9
PowerXL Air Fryer Oven™
10-Quart