Advertisement
4
STEP 8
PERFOR MANCE CHECK
1.
Move breaker handle to "OFF" position to reset breaker.
2.
With coil deenergized, move breaker handle towards "ON"
position. Breaker should trip and handle should come to
rest in the tripped position when released.
Apply 80% of rated voltage to coil (use dropping resistor if
3.
required). Repeat Step 1, then move handle to "ON"
position. Breaker should turn "ON" and stay "ON".
4.
Reduce coil voltage. Device should trip breaker between
35% and 70% of rated voltage.
STEP 9
LOCATI ON OF LABELS
Rating Label Location
Paste the Rating Label on the Base as shown in the
1.
Figure 11.
Tick the respective Voltage Rating in the check Box
2.
provided in the Rating label to be offered to Customer
—
Figure 11.
These instructions do not purport to cover all details or variations in equipment nor, to
provide contingency to be met in connection with installation, operation, or
maintenance.
arise which are not covered sufficiently for the purchaser's purposes, the matter should
be referred to ABB Company.
—
—
ABB Inc.
GE is a trademark of GE. Manufactured
305 Gregson Drive
by ABB Inc. under license from GE.
Cary, NC 27511.
electrification.us.abb.com
Rating Label
Should further information be desired, or should particular problems
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With
regard to purchase orders, the agreed
particulars shall prevail. ABB Inc. does not
accept any responsibility whatsoever for
potential errors or possible lack of
information in this document.
Align vertical edge of the Rating Label
with the Base vertical edge reference
Align horizontal bottom edge of
Rating Label with the barcode label
top edge
Line and Load Labels
Paste the Line and Load Labels on the top of
the Cover as shown in the Figure 12.
—
Figure 12.
We reserve all rights in this document and
in the subject matter and illustrations
contained therein. Any reproduction or
utilization of its contents – in whole or in
parts – is forbidden without prior written
consent of ABB Inc.
Copyright© 2019 ABB
All rights reserved
Advertisement
