Table of Contents
Advertisement
2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
2.
INSTALLATION PROCEDURE FOR OPTIONAL
EQUIPMENT
1. Disconnect the power cord before installing the optional parts.
2. Be careful not to short-circuit the lithium battery on the ENGINE PC board.
This section describes procedures to install optional equipments into the POS terminal.
2.1 Removing/Attaching the Top Cover
• Removing the Top Cover
1)
Loose these 2 of plastic thumbscrew of the top cover.
2)
Press the top cover from the left side and right side and then slide it down.
WARNING!
Plastic thumbscrew
Turn it anticlock w ise to loose the
plastic thumbscrew
1) Press the top cover at
left side and right side
2) Slide it dow n
2- 1
EO18-12017
2.1 Removing/Attaching the Top Cover
Advertisement
Table of Contents
