When you replace the system board, be sure to remove the following components (as applicable) from the
defective system board and install them on the replacement system board:
Memory modules (see
●
WLAN module (see
●
Solid-state drive (see
●
Heat sink (see
Heat sink on page
●
Remove the system board:
1.
Disconnect the following cables from the system board:
Power connector (DC-in) board cable (1)
●
WLAN antennas from the WLAN module (2)
●
●
Display cable (ZIF) (3)
●
Keyboard backlight cable (ZIF) (4) (select products only)
●
Keyboard cable (ZIF) (5)
●
USB board cable (ZIF) (6)
●
Touchpad cable (ZIF) (7)
Speaker cable (8)
●
Fingerprint reader cable (ZIF) (9) (select products only)
●
2.
Remove the four Phillips M2.0 × 3.0 screws (1) that secure the system board to the computer.
Memory modules on page
WLAN module on page
30).
Solid-state drive on page
41).
33).
32).
Component replacement procedures
45