Replacing The Remote Control Battery; Setting Up The Device; Providing Mains Power; Vhf Cable Antenna - Silvercrest SIUR 10 A1 Operating Instructions Manual

Replacing the remote control battery

GB

Setting up the device

Providing mains power

VHF cable antenna

Handling and use

Switching on and off
130
♦ Insert the battery into the battery compartment. The side with the marking
"+" must be facing upwards.
♦ Close the battery compartment by attaching the cover and then, using a
coin, turn it to the right as far as it will go.
Before using the remote control for the fi rst time, you
will have to pull out the plastic strip protruding from
the battery compartment. This plastic strip insulates
the battery and prevents it discharging prematurely.
If the remote control is no longer functioning reli-
ably, you have to replace the battery. To do this,
press the lock tab in the direction of the arrow with
your fi ngernail, and pull the battery carrier out of
the remote control. Remove the discharged battery
and then place a fresh battery of the same type
(CR2025) in the carrier so that the "+" marking is
facing upwards. Slide the battery carrier back into
the remote control.
♦ Select a suitable location for the device (you should also refer to chapter
Requirements for the set up location).
♦ Insert the mains connecting cable plug
display (0:00) is shown in the display
♦ Completely unwind the cable antenna
This section provides you with important information on handling and using the
device.
Once the device has been connected to the power supply it is already switched
on. You can switch between clock/standby and radio operating mode using the
key on the device or the
into a mains socket. The time
.
for VHF radio reception.
key on the remote control.
SIUR 10 A1