Initial Commissioning; Installing The Bea; Installing The Hoses And Connection Cables; Selecting The External Network Printer - Bosch BEA 750 Original Instructions Manual

5.

Initial commissioning

5.1

Installing the BEA 750

1. Remove the packaging from all components
supplied.
i
Make use of the local return and collection systems for
disposal of packaging.
!
Proper disposal of the packaging material prevents
environmental pollution and possible health hazards.
2. Place the BEA 750 on a stable surface (e. g. a work
table).
3. Insert the power plug (fig. 2, item 11) into the
BEA 750.
5.2 Installing the hoses and connection
cables
1. Connect the two PVC hoses to the measurement gas
and condensate outlets on the BEA 750.
2. Connect hose (1 680 703 043) to the measurement
gas inlet of the BEA 750.
3. Connect the coarse filter (fig. 4, item 2) between the
hose 1 680 703 043 (fig. 4, item 1) and the hose for
the exhaust gas sampling probe (fig. 4, item 3).
4 3 2
Fig. 4:

Installing the hoses and connection cables

"
Initial commissioning of the BEA 750 is completed.
Robert Bosch GmbH
1
Initial commissioning | BEA 750 | 25
5.3 Selecting the external network
printer
!
Repeaters installed in the WLAN can cause
communication interruptions when using a network
printer. Make sure that the repeater permits data
exchange via broadcast or multicast messages.
Provide the same functionality for a switch and
router.
i
To print out the protocols (test records) on an
external network printer, it is first necessary to set
up a network connection for the network name
(SSID) in the BEA-PC software under "Settings >>
Operating System >> WLAN" (see Online Help).
1. In the BEA-PC software, open "Settings >>
Protocol".
2. Insert the USB stick into the USB port (rear of the
BEA 750).
3. Select "Printer >> External Network Printer".
4. After a short time, <F8> Print Service appears.
5. Press <F8>.
 The file 'PrintServiceSetup.exe' is saved on the
USB stick.
6. Remove the USB stick from the BEA 750, and insert
it in the selected network computer.
7. Start the file 'PrintServiceSetup.exe' on the USB
stick.
8. Follow the instructions on the screen.
 Once installation is complete, the active printers
in the network are displayed in the BEA-PC soft-
ware under "Settings >> Protocol".
9. Select the printer.
10. Press <F12> to save changes and return to the
"Settings" window.
"
The external network printer is configured.
i
In rare instances, no active printer is displayed in
the indicator panel under "Settings >> Protocol"
when selecting the network printer. In this case, the
BEA 750 must be restarted.
en
|
1 689 989 339 2017-12-12