Replacing A Water Sensor (Point Type) - Huawei FusionModule1000A40 Maintenance Manual

FusionModule1000A40 Prefabricated All-in-One
Data Center
Maintenance Guide
Step 8 Check that the new camera is working properly.
----End

5.3.6 Replacing a Water Sensor (Point Type)

Prerequisites
Spare water sensors of the same model are available and functional.
Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Material: spare water temperature sensor
Documents: monitoring device layout diagram, management system initial
configuration table
Skill requirement: weak-current engineer
Procedure
Step 1 Locate the water sensor to be replaced based on the alarm information on the
monitoring software terminal.
Figure 5-26 Point-type water sensor
Step 2 Remove the locking bolts of the water sensor using a Phillips screwdriver, and
remove the water sensor, as shown in
Issue 04 (2021-02-10)
NO TE
The original parameter settings can be used.
Copyright © Huawei Technologies Co., Ltd.
Figure 5-26 shows a point-type water sensor.
Figure 5-27.
5 Parts Replacement
83