Operating The Optisonde - GE OptiSonde User Manual

October 2007

Operating the OptiSonde

3-2
The parameters chosen during programming are displayed
numerically in the middle of the screen. For programming, see
Chapter 4. A typical OptiSonde display screen is shown in Figure 3-1
below. The system status and heating/cooling indicator (small arrow)
are shown in the upper right, and the balance indicator is shown in the
lower left.
Menu: x
e
mbar
T °C
a
Figure 3-1: Typical OptiSonde Display Screen
To control the sensor, press the
ESC
locked, press the key, followed by the
ESC
key again.) The Function Control screen appears, as shown in
Figure 3-2 below. Use the four arrow keys to select the desired
function
Select Function:
PACER
Figure 3-2: Function Control Screen
Auto Cycle
6.0179
+25.09
14:33
ENT
key. (If the OptiSonde keys are
ENT
key, and then press the
HEAT
AUTO
COOL
Operation