Table of Contents
Advertisement
Problem
flashes/lights up
after the tumble
dryer is switched
on and a
programme
cannot be
selected.
and light up after
a programme has been
cancelled, a signal tone
sounds.
and another number
combination flash after
a programme has been
cancelled, a signal tone
sounds.
: lights up and the
programme has been
cancelled, a signal tone
sounds.
Possible cause and remedy
Access via a code has been activated.
See "Programmable functions - PIN Code".
The fluff filters and the plinth filter are clogged with
fluff.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways. This is the area underneath the
plinth filter and the heat exchanger.
See "Cleaning and care".
To switch the fault message off:
Switch the dryer off and back on.
There is no obvious cause.
Switch the dryer off and back on.
Start a programme.
If the programme terminates again with the same
error message, then there is a fault. Contact Miele.
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and back on.
Start a programme.
Problem solving guide
49
Advertisement
Table of Contents
