Wcdma Rf Testing Using Local Mode; Wcdma Tx Control - Nokia NHM-1 Series Software Instructions

NHM-1

WCDMA RF Testing Using Local Mode

Phoenix supports the following functions in local mode:
• TX control using either direct power control or uplink power control
• TX control to LNA and BB AGC. Algorithm Mode supports the RSSI measurements

WCDMA TX Control

Two modes are available:
•
•
• WCDMA TX control can be activated from Phoenix-menu:
• Manual mode:
Page 84
Manual mode is for direct control of the AGC's, PA Bias - and DC/DC-
converters. Also, modulation type, channel settings and different kinds of
sweeps with DACs can be run to study the phones behaviour
Algorithm mode can be used when TX (AGC's) are calibrated. Output
power can be set to fixed power levels or power sweeps can be run. Also
WCDMA signal code settings (scrambling and chanelisation codes can be
modified).
Testing/WCDMA/Tx Control
DA-converter setting for AGC's in TEX and HEX (0...1023 )
DA-converter for PA bias control ( 0...15 )
DA-converter setting for DC/DC-converter ( 112 ... 512;
112 DAC~1.5 V DC/DC output voltage, 512 DAC ~3.3V )
When sweeping is used here the count and step duration
can be adjusted. Modulation selection is for WCDMA signal
or "CW"-signal. CW is actually a 300 kHz sinewave IQ-
signal which causes the +300 kHz offset into transmitted
frequency.
Here the uplink data- and control channel weighting can
be adjusted ( 0...15 )
Uplink channel number can be changed in here ( 9612 ...
9888 ).
NOTE: When settings are done, they're enabled after
pressing "Send". If settings are then changed ( e.g. new
channel number ) you must press "Stop" and "Send" again.
Copyright Nokia. All rights reserved.
CCS Technical Documentation
12
Issue 1 11/03