CCS Technical Documentation
WDCMA RF Tuning
The following contains information about RF tuning operations with Phoenix software.
Also included is information about WCDMA RF controls and tests run with this software.
WCDMA RF Tunings
Order for WCDMA RF tunings:
•
•
•
•
•
•
•
•
To run these with Phoenix SW, the phone must be in local mode with "WCDMA" system
selected.
WCDMA RF Channel Filter Tuning
This does not require any external instruments.
•
Run this component from the Phoenix menu:
•
This is the initial view. Press "Tune" to start calibration.
Note: You can also read values from memory with "Read".
The tuned values are settings for the baseband analog active low pass filters in REX and
TEX ASICs.
Issue 1 11/03
RX/TX channel filter calibration
Temperature sensor calibration
RX AGC tuning
RX band response
TX bias current setting
TX AGC tuning
TX power detector tuning
TX band response
Tunings/WCDMA/RF channel filter calibration.
Copyright Nokia. All rights reserved..
Save the tuned values into PM
( PM=permanent memory )
NHM-1
Page 73