BEKOMAT
®
13, 13 CO, 13 CO PN25, 13 CO PN40
10.3.3 Visual inspection
During the visual inspection, check all components for mechanical damage and corrosion. Replace damaged components
immediately.
10.3.4 Leakage test
The leakage test is a non-destructive test method and is used to prove leak tightness in vacuum and overpressure
systems. The leakage test can be carried out in different ways. BEKO TECHNOLOGIES GmbH does not make a
specific recommendation here. The company operating the compressed gas system is responsible for the selection
and specification of the test method to be used, which should be executed in accordance with valid standards and
regulations (e.g. DIN EN 1779).
11. Consumables, accessories and spare parts
11.1 Order information
BEKO TECHNOLOGIES Service requires the following data for an inquiry or order:
•
Serial number of the product (see type plate)
•
Material number and designation of the accessory or spare part
•
Required quantity of accessories or spare parts to be delivered
The contact data for the BEKO TECHNOLOGIES customer services responsible are listed in chapter "1.1 Contact" on
Page 4.
46 | 64
Original installation and operation manual