LG niagara4 MultiSITE Edge 10 User Manual page 32

Note:
IPv6 support is available; however this document focuses on IPv4 configuration. For details on IPv6, refer to the Niagara
Platform Guide section on TCP/IP Configuration.
Daisy chain mode
By default the MS-E10 device is factory shipped in the daisy chain link mode. The Daisy Chain/STP settings are configured
during the TCP/IP step of the Commissioning Wizard and during distribution file install procedure.
Note:
The STP settings are available only when Link Mode is configured for Daisy Chain.
Figure 19: Link Settings in TCP/IP Configuration
Configuring TCP/IP settings
Perform the following steps to configure the device's TCP/IP settings.
Step 1: Review the Interface 1 settings on the IPv4 Settings tab, which include the temporary factory- shipped IP address.
Step 2: Assign the MS-E10 device a unique IPv4 address for the network you are installing it on. No other device on this network
should use this same IP address. Include the appropriate subnet mask used by the network.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
MS- E10 User Guide
32