ABB BullsEye Applications Manual page 26

3 Installation
Continued
Start-up test
Do a start-up test before running BullsEye.
1
2
26
Action
Make sure that the digital input connected to the scanning device is responding
correctly, by verifying that the signal is defined as an input on an I/O board.
Pass your hand through the BullsEye yoke beam to break the beam. The LED on
the I/O board corresponding to the input should turn on when the beam is broken.
If it does not, verify that the I/O board is configured properly and that the wiring is
correct.
© Copyright 2004-2018 ABB. All rights reserved.
Application manual - BullsEye
3HAC050989-001 Revision: C