Hitachi RCI Service Manual page 225

6 Optional functions
E9 – Not used
Settings
00
01
EA – Not used
Settings
00
01
Eb – Fan operating control after stoppage of the indoor unit in cooling mode
This function reduces the unit fan speed to reduce the spreading of smells and humidity.
Setting condition
00
01
02
EC – Fan operating control after stoppage of the indoor unit in cooling mode
This function is used to force stoppage when cooling is complete. It is effective for avoiding unpleasant smells, as the heat
exchanger remains clean, e.g. it is rinsed with drainage water.
Setting condition
00
01
02
Ed – Not used
EE – Automatic fan speed control
This function is useful to economise the operating time and limit the operating of the unit by automatically controlling the
fan speed when the room temperature is close to the set temperature. The following table shows the change of fan speed:
N O T E
This function is available for PC-ART and all indoor units except RPI(8.0/10.0)FSN2E
The configuration fan speed
High
Medium
Settings
00
01
F1 – Automatic timer off setting
This function is used to switch off the timer automatically when the unit is started using the remote control.
213
SMGB0063 rev. 1 - 10/2010
Used as setting for conditions 00
Fan operation with the thermostat switched off
Fan operation with the thermostat switched off
Low
Condition setting
Not used
Condition setting
Not used
Used as setting for conditions 00
Not available
Low
Slow
Fan at set speed
Low
Slow
Speed setting
High→ Medium→ Low
Medium→ Low
Low (no change)
Condition setting
Not available
Available
6