Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. SAFETY
1.1.
GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
Familiarise yourself with the application, limitations and potential hazards of the device.
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Locate device in a suitable working area, keep area clean and tidy and free from unrelated materials.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the device clean for best and safest performance.
9
Ensure there are no flammable or combustible materials near the work area.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Wear heat resistant gloves and appropriate protective clothing.
9
Ensure the workpiece is adequately held before operating the device.
9
Always use the stand provided when not using the hot tool so that the tip cannot make contact with the work surface.
9
Always use device in a well ventilated atmosphere or alternatively wear respiratory protection.
9
Ensure that when the device is put down during use that the tip is not near to or in contact with any material that may burn or
9
melt.
After use always keep the plastic welder in its original package in a safe place away from children.
9
DO NOT touch the staple or tip during its warm up phase.
8
DO NOT use in wet or damp conditions.
8
DO NOT operate the device when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT leave the device hot and unattended. (If you are leaving the work area even for a short period of time switch it off and allow
8
to cool.)
DO NOT use the device for any purpose other than that for which it has been designed.
8
DO NOT allow untrained persons to operate the device.
8
DO NOT touch the workpiece as it will be very hot. Allow to cool.
8
DO NOT operate the device if damaged.
8
1.2.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
© Jack Sealey Limited
50W LITHIUM-ION RECHARGEABLE PLASTIC
WELDING REPAIR KIT
SDL14
MODEL NO:
Wear protective
Hot surfaces
gloves
Original Language Version
Indoor use only Wear respiratory
protection
SDL14 Issue 1 28/04/20