Table of Contents
Advertisement
4.8 Configure speaker lines
A6V11899867_en--_a
5. Mount and screw the amplifier matrix adapter onto the designated position in
the connection area.
6. Use the CAT5 cable to connect the RJ45 connector on the amplifier to the
RJ45 connector on the amplifier matrix adapter. (This cable is not used as an
Ethernet connection. It is used for the analog audio in, and for the control and
status information.)
7. Connect the amplifier to the mains connector X102 with the 230 V wiring to
build the internal 230 V wiring.
8. Connect the 24 V wiring.
9. Mount the other required power amplifiers PV1002-A1 as described in steps
1...8.
10. Re-mount the power supply with 4 screws and connect all the wiring.
11. Connect the amplifiers 24 V wiring to the power supply.
Fig. 13: PV1002-A1 amplifier matrix adapter
Amplifier matrix adapter to power amplifier PV1002-A1
LED
Description
AC
Green
DC
Green
Operate
Green
Clip/Temp Yellow
Fault
Yellow
Table 11: Amplifier matrix adapter to power amplifier PV1002-A1
The fault and clip LEDs are active when the amplifier is in OFF mode.
The Cerberus PACE Compact speaker line configuration is performed via the
speaker lines jumper configuration matrix.
The speaker lines can't be configured via the configuration tool 'PACE-Design', but
the speaker line jumper settings can be checked in the 'PACE-Design'.
Mounting/Installation
Configure speaker lines
Remark
Active: AC voltage is ok
Active: DC voltage is ok
Active: the amplifier is ready (at least one
supply voltage is ok, and the amplifier is not
in OFF mode)
Active: the amplifier is clipping (signal too
high), or the amplifier temperature is too high
The amplifier is in protection mode
4
39 | 122
Advertisement
Table of Contents
