Restore - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Operating the Control Panel
5.9 Service and Commissioning
4. Start the restore process via the "OK" button or cancel the process via the "Cancel"
button.
The HMI device restarts after the "OK" button is pressed. The restore process then
begins.
During the restore process, the "Automatic backup restore" dialog box is displayed with a
progress bar.
The HMI device is restarted again after the completion of the restore process.
The main window of the Control Panel is displayed after the restart.
After the data transfer, the state of the HMI device is the same as that of the HMI device
used to generate the automatic backup.
To continue the automatic backup on the HMI device, reactivate the "Automatic backup"
function under "Service and Commissioning" > "Automatic Backup" in the Control Panel.
See also
Accessories (Page 16)
Backup (Page 106)
Changing the memory card (Page 72)
5.9.5

Restore

Under "Restore", you can restore the backup of an HMI device from a storage medium.
Remote access to the HMI device is not possible during the restore process.
A restore operation deletes the flash memory of the HMI device on confirmation. The data
backed up on the storage medium is then transferred.
NOTICE
Data loss
All data on the HMI device, including the project and HMI device password, is deleted
during a restore operation. License keys are only deleted after a security prompt.
Back up your data before the restore operation, if necessary.
Select storage media
Select the storage medium on which the backed-up data is stored.
112
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA