Table of Contents
Advertisement
6.6.13 To disassemble the pinion shaft
1. Attach the pinion shaft to a vise with soft jaws.
2. Remove the shim ring (A), the hex nut (B), the plate
spring (C), and the pressure disc (D). Remove the
brake disc (E), the gear wheel (F), the bearing
sleeve (G), and the brake disc (H).
1332 - 001 - 04.03.2021
A
B
C
D
E
F
G
H
3. Clean and dry all parts. Examine all parts for wear.
Replace damaged parts.
6.6.14 To assemble the pinion shaft
1. Put gear oil on all parts before assembly. Make sure
to put gear oil on the two sides of the brake discs.
Install the brake disc (A), the bearing sleeve (B), and
the gear wheel (C). Install the brake disc (D), the
pressure disc (E), the plate spring (F), and the hex
nut (G).
2. Put the pinion shaft into the pinion shaft holder as
the illustration shows. Tighten the hex nut slightly
with a wrench. Refer to
G
F
E
D
C
B
A
Servicing tools on page 6 .
Repair and servicing - 25
Advertisement
Table of Contents
