Flash Messages - GE Multilin 489 Instruction Manual

CHAPTER 6: ACTUAL VALUES
6.8.2

Flash Messages

[.] KEY IS USED TO
ADVANCE THE CURSOR
DATA CLEARED
SUCCESSFULLY
DEFAULT MESSAGE
LIST IS FULL
INVALID PASSCODE
ENTERED!
NO ALARMS ACTIVE
PRESS [ENTER] TO
REMOVE MESSAGE
TACHOMETER MUST USE
INPUT 4, 5, 6, OR 7
TIME ENTRY
OUT OF RANGE
489 GENERATOR MANAGEMENT RELAY – INSTRUCTION MANUAL
Courtesy of NationalSwitchgear.com
ACTIVE ALARMS:
START BLOCK
LOCKOUTS:
When the has been pressed and the hot RTD condition is no longer present, the
RESET
display will revert back to the normal default messages.
Flash messages are warning, error, or general information messages that are temporarily
displayed in response to certain key presses. These messages are intended to assist with
navigation of the 489 messages by explaining what has happened or by prompting the
user to perform certain actions.
Table 6–2: Flash Messages
ACCESS DENIED, ACCESS DENIED,
ENTER PASSCODE SHORT ACCESS SWITCH
DATE ENTRY DATE ENTRY WAS
OUT OF RANGE NOT COMPLETE
END OF LIST
DEFAULT MESSAGES
6 TO 20 ARE ASSIGNED
INVALID SERVICE CODE KEY PRESSED IS
ENTERED INVALID HERE
NO TRIPS OR ALARMS OUT OF RANGE.! ENTER:
TO RESET #### TO ##### BY #
RESET PERFORMED ROUNDED SETPOINT
SUCCESSFULLY HAS BEEN STORED
THAT DIGITAL INPUT THAT INPUT ALREADY
IS ALREADY IN USE USED FOR TACHOMETER
TOP OF LIST
TIME ENTRY WAS
NOT COMPLETE
• NEW SETPOINT HAS BEEN STORED: This message appear each time a setpoint has
been altered and stored as shown on the display.
• ROUNDED SETPOINT HAS BEEN STORED: Since the 489 has a numeric keypad, an
entered setpoint value may fall between valid setpoint values. The 489 detects this
condition and store a value rounded to the nearest valid setpoint value. To find the
valid range and step for a given setpoint, press the
being displayed.
• OUT OF RANGE! ENTER: #### TO ##### BY #: If a setpoint value outside the
acceptable range of values is entered, the 489 displays this message and substitutes
proper values for that setpoint. An appropriate value may then be entered.
STATOR RTD #1
ALARM: 135°C
OVERLOAD LOCKOUT
BLOCK: 25 min
ALL POSSIBLE RESETS ARE YOU SURE? PRESS
HAVE BEEN PERFORMED [ENTER] TO VERIFY
DEFAULT MESSAGE DEFAULT MESSAGE
HAS BEEN ADDED HAS BEEN REMOVED
END OF PAGE
ENTER A NEW
PASSCODE FOR ACCESS
NEW PASSCODE NEW SETPOINT HAS
HAS BEEN ACCEPTED BEEN STORED
PASSCODE SECURITY PRESS [ENTER] TO ADD
NOT ENABLED, ENTER 0 DEFAULT MESSAGE
SETPOINT ACCESS IS SETPOINT ACCESS IS
NOW PERMITTED NOW RESTRICTED
THIS FEATURE NOT THIS PARAMETER IS
PROGRAMMED ALREADY ASSIGNED
TOP OF PAGE
key while the setpoint is
HELP
6–33