Acer Extensa 700 User Manual page 17

Command Function
&J1 Not supported, responds ERROR
&K0 Disable flow control
&K3 Enable RTS/CTS flow control
&K4 Enable XON/XOFF flow control
&M0 Asynchronous mode (default)
&P0 34/66 make/break ratio (default)
&P1 33/55 make/break ratio (20 pps)
&Q0 Asynchronous mode, buffered
&Q5 Error control mode, buffered
&Q6 Asynchronous mode, buffered
&Q8 MNP error control mode
&Q9 V.42 or MNP error control mode
&S0 DSR always ON (default)
&S1 DSR is off in command mode, on
in online mode
&T0 Abort. Stops any test in progress.
&T1 Run local analog loop
&T3 Run local digital loopback
&T6 Run remote digital loopback test
&V0 View active file
&W0 Store current configuration
&Y0 Select stored profile 0 on power-up
&Y1 ERROR
&Zn=x Store telephone number x into
non-volatile RAM, n=0-3
\G0 Returns an "OK" for compatibility
\G1 Not supported, responds ERROR
\J0 Turn off adjust bits/rate feature
(default)
AT Commands
Command Function
\J1 Turn on feature
\K5 Modem sends the break to the
remote modem in sequence with
the transmitted data, non-
destructive non-expedited
\N0 Buffer mode. No error control.
\N1 Direct mode
\N2 MNP or disconnect mode
\N3 V.42, MNP or buffer (default)
\N4 V.42 or disconnect
\N5 V.42 MNP or buffer
\N7 V.42 MNP or buffer
\Q0 Disable flow control
\Q1 XON/XOFF software flow control
\Q2 CTS-only flow control
\Q3 RTS/CTS to DTE (default)
\V0 Disable protocol result code
appended DCE speed
\V1 Enable protocol result code
appended DCE speed
\Tn Inactivity timer (in minutes)
-C0 Data calling tone disabled (default)
-C1 Data calling tone enabled
\X0 Modem processes XON/XOFF
flow control characters locally
(default)
\X1 Not supported, responds ERROR
%B View numbers in blacklist
%C0 V.42bis/MNP 5 disabled. No data
compression.
13