Siemens SITRANS P Operating Instructions Manual page 102

Parameter assignment
9.1 Overview of parameters and functions
Current output
Set fault current
Set saturation limits
Digital-to-analog converter trim
Loop test
Application
Select pressure units
Select the temperature unit for sensor and elec‐
tronics temperature
Set additional measuring task (e.g. level, volume
flow, mass flow, volume, set customized charac‐
teristic curve)
Set customized characteristic curve
Set scaling points
Select unit of scaled value
102
SIMATIC PDM Device with display (lo‐
cal operation)
"Settings > Current out‐ Select fault current [10]
put" parameter group (Page 124)
Lower fault current [11]
(Page 124)
Upper fault current [12]
(Page 125)
"Settings > Current out‐ Lower saturation limit
put" parameter group [13] (Page 125)/Upper
saturation limit [14]
(Page 126)
Menu command "De‐ -
vice > DAC trim"
Menu command "De‐ Loop test [31]
vice > Loop test" (Page 141)
SIMATIC PDM Device with display (lo‐
cal operation)
"Settings > Units" pa‐ Display of the pressure
rameter group units (Page 107)
"Settings > Sensor Temperature units [17]
temperature units" pa‐ (Page 130)
rameter group
"Settings > Select out‐ Application [05]
put > Application" pa‐ (Page 110)
rameter group
Menu command "De‐ -
vice > Customized
characteristic curve"
"Settings > Current out‐ Lower scaling point
put > Scaling" [18] (Page 130)/Upper
scaling point [19]
(Page 132)
"Settings > Current out‐ Units [16] (Page 127)
put > Scaling > Units"
Device without display
(local operation)
Commissioning the de‐
vice without display
(Page 11)
-
-
-
Device without display
(local operation)
-
-
-
-
-
-
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC