Disconnecting; Lan - Toshiba PA3314U User Manual

User's Manual

Disconnecting

To disconnect the modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the Port Replicator in the same manner.
NOTE: If you use a storage device such as a CD-ROM drive or HDD
connected to a 16-bit PC Card, you might experience the following
modem problems:
1. Modem speed is slow or communication is interrupted.
2. Skips may occur in sound.

LAN

The Port Replicator supports Ethernet LAN, Fast Ethernet LAN and Gigabit
Ethernet LAN. If the computer does not support Gigabit Ethernet LAN (1000BASE-
T), the Port Replicator supports only Ethernet LAN (10BASE-T) and Fast Ethernet
LAN (100BASE-Tx).
CAUTION: The computer must be configured properly before connect-
ing to a LAN. Logging onto a LAN using the computer's default settings
could cause a malfunction in LAN operation. Check with your LAN
administrator regarding set-up procedures.
If you are using Gigabit Ethernet LAN (1000 megabits per second, 1000BASE-T), be
sure to connect with a CAT5 cable or a CAT5E cable. (A CAT5E cable is recom-
mended.) You cannot use a CAT3 cable.
If you are using Fast Ethernet LAN (100 megabits per second, 100BASE-TX), be
sure to connect with a CAT5 cable. You cannot use a CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you can
connect with either a CAT5 or a CAT3.
4-2