Table of Contents
Advertisement
24
en | Reader Functionality
5.9
Return to Factory Default Settings
CAUTION!
You must be very careful before using this command! This will
erase the entire memory and return all codes to their factory
default setting.
1.
2.
3.
5.10
Replacing a Lost Programming Code
In the event that the Programming Code is forgotten, the ARD-
AYCE65B may be reprogrammed in the field using the following
instructions:
1.
2.
3.
4.
| V 1.1 | 2009.08
Enter Programming Mode.
Press "0" to enter Menu 0.
The Transmit LED will Flash red.
The Program LED will flash red.
Enter your 4 digit programming code
–
If the Programming Code is valid, all memory will be
erased, you will hear three beeps and the controller
will return to Normal Mode
–
If the Programming Code is invalid you will hear a long
beep and the controller will return to Normal Mode
without erasing the memory of the controller
Remove power from the reader.
Activate tamper by removing the reader from the wall or
removing the reader's case.
Apply power to the reader.
You now have 10 seconds to enter Programming Mode
using the factory default Programming Code 1234.
Installation manual
ARD-AYCE65B
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
