Husqvarna 122C Workshop Manual page 13

Electrical system
Separate the short-circuit cables.
Remove the screws (A) and slide the
throttle forwards.
Loosen the screws and remove the shaft
from the engine.
Remove the 3 screws and lift off the cover.
Remove the screws and lift off the ignition
module.
502 71 27-02
Separate both short-circuit cables.
Remove both screws (A), one on each
side of the throttle handle.
Push the throttle forward onto the shaft.
Loosen the screws and remove the shaft
from the engine.
Remove the 3 screws shown in the illus-
tration and lift off the cover over the clutch/
fl ywheel.
Remove the screws and lift off the ignition
module.
2
11