GE Profibus - DP Bus Instructions Manual page 23

Destination option not exist
Parameter Access Conflict
Value out of the max range
Value out of the min range
Value not supported
Parameter Configuration Conflict
Command Submitted
Unknown Command
Read only Parameter
Write not allowed
Value out of constant limits
State not correct
Password
Type Unknown
Hardware Fail
Checksum Fail
NOK generic
GEI-100346
The destination option does not exist at node
The addressed parameter can not be accessed (for example if the com-
mand is write and parameter is connected to an external input)
Value is out of the maximum range
Value is out of the minimum range
Value is in range but not allowed
The addressed parameter cannot be accessed for sistem configuration
conflict (for example the order try to connect an input source to a pa-
rameter that is already connected to an input source)
Command has been submitted but is not possible to know if it has been
exucuted I
The command in the order message is not known
The parameter has read only attribute
Write operation is not allowed for the slave conditions
Value is out of constant fixed limits
The control state doesn't allow the command execution
The command is not executed because the password is not active
The parameter type is not known
The access is denied because of an hardware failure
The access is aborted because of an error in cheksum control
The access is aborted because of an indeterminated error
SERVICE ERROR CODES AND OPERATION RESULT
.b