Yamaha 9000 Pro Owner's Manual page 97

• FILTER RATE and FILTER LEVEL (Filter EG settings)
The FILTER RATE parameters are time-related; they determine how long it takes for the
sound's timbre to change from level to level (as set in FILTER LEVEL).
The FILTER LEVEL parameters are filter-related; they determine how much the sound
changes in timbre over time (as set in FILTER RATE). A setting of "0" is the default value.
FILTER RATE INITIAL
DECAY1
DECAY2
DECAY3
RELEASE
SUSTAIN
FILTER LEVEL INITIAL
DECAY1
DECAY2
DECAY3
SUSTAIN
G E3: FILTER
The 9000Pro features two independent filters. (For basic information about the filters,
see page 93.)
Sets the cutoff frequency of Filter1.
Selects the type of Filter1.
Filter types
LPF (Low Pass Filter)
Level
These frequencies are
"passed" by the filter.
BPF (Band Pass Filter)
Level
Cutoff range
Center frequency
Sets the length of time the initial filter envelope level will be maintained. Higher values
correspond to shorter time.
Set the rate of variation between the initial filter envelope level and the levels set by the
FILTER LEVEL DECAY1, DECAY2, and DECAY3 parameters, respectively.
Sets the rate of variation from the offset at key-release to the offset set by the FILTER
LEVEL RELEASE parameter when SUSTAIN is off.
Sets the rate of variation from the offset at key-release to the offset set by the FILTER
LEVEL SUSTAIN parameter when SUSTAIN is on.
Sets the initial timbre of the envelope.
Set the amounts of timbre change following the elapsed time of DECAY 1, DECAY 2,
and DECAY 3, respectively.
When SUSTAIN is on, this sets the final timbre of the envelope; the filter setting chang-
es to this point (at the RELEASE rate) after the key is released.
Sets the amount of peak resonance applied to FILTER 1.
Higher values produce more resonant emphasis.
The TYPE parameters specifies the touch-sensitivity curve to
be applied to the dynamic filters, and the SENS parameters
sets the sensitivity of the filters to touch control. Higher values
produce higher sensitivity.
Resets the currently selected EG parameters to
their most basic settings.
Sets the cutoff frequency of Filter2.
Selects the type of Filter2.
HPF (High Pass Filter)
Frequency
Cutoff frequency
BEF (Band Elimination Filter)
Level
Range passed Cutoff range
Frequency
Level
Cutoff range Range passed
Frequency
Cutoff frequency
Range passed Cutoff range Range passed
Frequency
Center frequency
Custom Voice Creating
Custom Voice Creating
97
Reference