Device Serving As The Tftp Client To Upload Or Download Files Through Tftp - Huawei USG6000 Upgrade Manual

HUAWEI USG6000&USG9500
Upgrade Guide
[ftp] binary
mode.
[ftp] get temp.cc
After the downloading is complete, check whether the sizes of files in the CF card are the
same as those on the FTP server. If no, re-download the files to ensure that they are
completely downloaded to the CF card.
----End
2.5.2 Device Serving as the TFTP Client to Upload or Download
Files Through TFTP
Context
As shown in Figure 1, PC2 serves as the TFTP server. Log in to the TFTP server from the
USG9500 and upload or download files through TFTP. This method requires the third-party
TFTP server software to be installed on the PC2.
Figure 2-20 Schematic diagram of uploading/downloading files through TFTP and with the
USG9500 serving as the TFTP client
Procedure
Step 1 Configure the TFTP server.Install the TFTP server program on PC2 and configure the TFTP
server using the document available with the program. Suppose that you obtain the TFTP
server program in a legitimate way and description of the program is beyond the coverage of
this document. The following operation assumes that the root directory of the TFTP server is
set to the storage path of files to be uploaded/downloaded.
Step 2 Log in to the USG9500 from PC1 through Telnet/SSH.
Step 3 Upload files in storage media of the USG9500 to the TFTP server.Run the tftp ip-address put
source-filename [ destination-filename ] command in the user view to upload files to the
TFTP server. The following operation assumes that the IP address of the TFTP server as
192.168.0.2.
<USG9500> tftp 192.168.0.2 put test.cc
Issue 01 (2018-01-16)
/Run the binary command to specify file transmission in binary
NOTE
You can also use a PC as both the Telnet/SSH client and the TFTP server. The following example
describes takes the two-PC deployment.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 USG9500
182