Plumbing Problems; Performance Data Sheet; Accessories - Kenmore 106.89592100 Technical Education

INSTALLATION ANd OperATINg INSTrucTIONS

Plumbing Problems

PROBLEM
Water Not Entering Drain
Properly

Performance Data Sheet

Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the
system, as specified in NSF/ANSI Standards 42.
Substance Reduction NSF Reduction
Aesthetic Effects Requirements
Chlorine Taste/Odor 50% reduction
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).
It is essential that operational, maintenance, and filter replacement
I
requirements be carried out for the product to perform as advertised.
Use replacement filter P6RFWG2K, P6RFGEG2K, P6RFKG2K, Part
I
Number ICE2.
Style 1 – When the water filter status display changes from "GOOD"
to "ORDER," order a new filter. When the filter indicator reads
"REPLACE," it is recommended that you replace the filter.
Style 2 – Press FILTER to check the status of your water filter. If the
filter indicator light is yellow and the words "ORDER FILTER" appear
on the display screen, order a new filter. If the filter indicator light is
red, it is recommended that you replace the filter.
These contaminants are not necessarily in your water supply. While
I
I
testing was performed under standard laboratory conditions, actual
performance may vary.
The product is for cold water use only.
I
I
Do not use with water that is microbiologically unsafe or of unknown
I
quality without adequate disinfection before or after the system.
Refer to the "Warranty" section for the Manufacturer's name, address
I
and telephone number.
® NSF is a registered trademark of NSF International.
I
I
I
n
2-22
WARNING
WARNING
Excessive Weight Hazard Excessive Weight Hazard
Use two or more people to move and install ice maker.
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury. Failure to do so can result in back or other injury.
RECOMMENDED SOLUTIONS
If the drain hose is not aligned over the drain, move the ice maker to align the drain.
NOTE: Service technicians cannot repair plumbing problems outside of the ice maker. Call a licensed, qualified
plumber.
Ice Maker Water Filtration System
System tested and certified by NSF
International against NSF/ANSI
Standard 42 for the reduction of
Chlorine Taste and Odor.
Average Influent Challenge
System tested and certified by NSF
Influent Concentration
International against NSF/ANSI
1.9727 mg/L 2.0 mg/L ± 10%
Standard 42 for the reduction of
Chlorine Taste and Odor.
Maximum Average
Effluent Effluent
0.71 mg/L 0.7788 mg/L
Refer to the "Warranty" section for the Manufacturer's limited
I
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
I
I
Minimum % Average %
Reduction Reduction
70.2 72.81
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8°C)
0.50 gpm (1.89 Lpm) @ 60 psi