Advertisement
1. Put a container below the drain plug for the engine
oil.
2. Remove the oil drain plug (A) and connect a hose
(B).
B
3. Tilt the product and let the oil run out into the
container.
4. Remove the hose.
5. Install the oil drain plug and tighten it.
6. Fill with new engine oil. Refer to the engine manual
for the correct type of oil.
7. Do a check of the engine oil level.
Air filter
WARNING: Use approved respiratory
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filter is dangerous to your
health.
CAUTION: Always replace a damaged air
filter, or the dust will go into the engine and
cause engine damage.
To clean or replace the air filter
WARNING: Do not clean the air filter with
compressed air. This causes damage to the
air filter and the risk increases that you
breathe the dangerous dust.
1. Turn the knob on the air filter cover and remove the
air filter cover.
14
2. Remove the paper filter element and the foam filter
element (A).
A
3. Clean the air filter housing with a brush.
4. Examine the air filter elements for damage.
5. Tap the paper filter element against a hard surface
or use a vacuum cleaner to remove the particles.
6. Clean the foam filter element with a solution of soap
and water.
7. Flush the foam filter element in clean water.
8. Compress the foam filter element to remove the
water and let the foam filter element dry fully.
9. Lubricate the foam filter element with engine oil.
10. Push a clean cloth against the foam filter element to
remove unwanted oil.
11. Install the air filter in the opposite sequence.
To do a check of the V-belt and adjust
the clutch wire
1. Stop the engine.
2. Remove the V-belt cover.
CAUTION: Do not let the nozzle of the
vacuum cleaner touch the surface of the
paper filter element. Keep a small
distance. The sensitive surface of the
paper filter element becomes damaged if
objects touch it.
WARNING: Do not operate the product
without the V-belt cover installed.
1071 - 001 - 11.12.2019
A
Advertisement
