Advertisement
4. Stop the product and remove it from the concrete
surface.
CAUTION: Do not let the product stay
stationary on the concrete surface. This
can cause marks and damages to the
concrete surface. When the product
stops, immediately lift the product from
the concrete surface.
To do the troweling operation
1. Make sure that the throttle control is set to full
throttle.
2. Turn the blade adjustment knob until there is tension
in the cable.
3. Move the product across the concrete surface.
a) Adjust the throttle control to an applicable speed
for the condition of the surface. Too high speed
can cause damage to the surface.
b) Adjust the blade adjustment knob as necessary
during operation.
4. Stop the product and remove it from the concrete
surface.
5. Wait until the concrete is sufficiently set.
6. Do the procedure again and again until the concrete
surface has a satisfactory finish and is fully set.
Note: The period of time between troweling operations is
calculated from how quickly the concrete sets.
To move the product in different
directions
•
To turn to the left, lift the handles.
1071 - 001 - 11.12.2019
•
To turn to the right, push the handles down.
•
To move the product forward, push the handles
forward.
•
To move the product rearward, pull the handles
rearward.
To adjust the blade angle
The blade angle is adjusted gradually.
1. To increase the blade angle, turn the blade
adjustment knob clockwise.
11
Advertisement
