To replace the sleeve for the lift sensor, the lift
sensor circuit board must also be removed by
bending the snap-on fastener.
6.
Refit all components, the chassis and body.
5.19 Changing and regreasing lower
front wheel bearing
1.
Disassemble the body. See 5.2.1 Disassembling
the body on page 59.
2.
Dismantle the front wheel by loosening the three
screws on the side of the wheel and then splitting
the wheel.
3.
Remove the lock washer from the axle.
4.
Remove the washer, ball bearing and the inner
front wheel half from the axle.
5.
Apply grease to both ball bearings.
6.
Refit the inner front wheel half, ball bearing and
washer.
7.
Fit a new lock washer onto the axle. NB! Do
not reuse the old washer as this will not give a
satisfactory lock after being removed from the
axle.
8.
Apply grease to the outer front wheel half before
assembling.
TH_1158203_310_315_GARDENA_US.indd 75
5. REPAIR INSTRUCTIONS
English - 75
2016-05-11 10:16:40