Tools And Equipment - HP A10500 Series Manual

x
The equipment room is at least 3 m (9.84 ft) high.
x
The dimensions of the rack are sufficient for the chassis. For more information about chassis
specifications, see the chapter "Appendix A Technical specifications."

Tools and equipment

Table 13 lists the tools and equipment that you might use during installation, and all of them are user
supplied.
Table 13 Tools and equipment list
Category
Measuring and
marking tools
Drills
Fastening tools
Small tools
Auxiliary tools
Tools for
fiber-optic
cleaning
Equipment
Tool
Long tape, ruler (of 1 meter, or 3.28 ft), gradienter, marker, chalk line, and pencil
Percussion drill, electric drill, and several auxiliary drill bits
Flat-blade screwdriver P4-75 mm
Phillips screwdriver P1-100 mm, P2-150 mm, and P3-250 mm
Socket wrench M5
Socket wrench M6
Needle-nose pliers, diagonal pliers, combination pliers, wire-stripping pliers, crimping
pliers, RJ-45 crimping pliers, file, and handsaw
ESD-preventive wrist strap, hair brush, tweezers, paper knife, hand bellows, electric iron,
solder wire, ladder, cable stripper, vacuum cleaner, crowbar, and rubber hammer
Lint-free paper and optical fiber microscope
Multimeter, 500 V Megohmmeter for measuring the insulation resistance, error detector,
optical power meter, and earth resistance tester
10