Philips EasyKey User Manual page 5

Put the mortise in the door and
3
align it with the screw tubes in the
outside escutcheon.
Put the mounting plate against the
5
inside of the door and fix it with the
four M5 chamber head screws.
6
Tighten the anchor screws in the
4
mortise.
Put the compressed spring and
6
then the square shaft in the inside
escutcheon accordingly.
Bigger end of the compressed
spring face to the handle
Socket for outside
escutcheon
Socket for mortise
connecting cable
connecting cable
Insert the connecting cables of
7
outside escutcheon and motor into
the corresponding sockets in the
inside escutcheon. Align the square
shaft of the inside escutcheon
to the rotary hole in the mortise
and insert it, then make the inside
escutcheon close to the inside of
the door.
2 M4 grub
screws in
flank
4 M4 screws
on the front
After all the above is finished, please check if every component is well connected
9
and if the lock works normally.
Fingerprint
sensor
Keypad
Card reader
Keep the multicolor ribbon under
8
the batteries while putting the fisrt
set of battery into the cabin, which
could make battery removal easier
for next battery replacement.
After all 8 batteries are in place,
install the battery cover and the
striker.
Close button
Mortise
Rotary knob
Reset button
A/M switch
7