Toro LT-F3000 Series Installation Instructions Manual page 5

2. Drill an 8 mm (5/16 inch) diameter hole on the center
of the bulkhead, 15 mm (5/8 inch) from the center line
of the bulkhead (Figure
Figure 5
1. Hole—6 mm (5/16 inch)
3. Use the bolts retained in step
(page 3) to mount the bottom tab of the bulkhead to
the machine (Figure
4. Mount the number plate bracket using 2 M6 x 30 mm
bolts and the washers retained in
Lights (page 3) as shown in
Figure 6
1. Number-plate bracket
2. Washer
5. Install the number plate to the number plate bracket
using 2 hex-head screws (M6), 4 washers (M6), and 2
locknuts (M6) as shown in
5).
3 of Mounting the Lights
6).
3 of Mounting the
Figure 6.
3. Bolt
Figure 7.
1. Hex-head screw (M6)
2. Washer (M6)
3. Number plate
6. Feed the number plate light cable through the 8 mm
(5/16 inch) hole in the bulkhead and install the light
to the bracket using 2 setscrews (M3 x 16), 2 washers
(M3), and 2 locknuts (M3; ) as shown in
1. Setscrew
2. Washer
7. Push the cable terminals into the plastic connector
(Figure 9).
5
Figure 7
4. Number-plate bracket
5. Locknut (M6)
Figure
Figure 8
3. Number plate light
4. Nyloc nut
8.