Driver Air Bag (Inflator) Module (For Vehicle With Air Bag System) - Suzuki RA410 Manual

3C-4 STEERING WHEEL AND COLUMN
1
c)
d)
a)
1
1
d)
1
b)
2
DRIVER AIR BAG (INFLATOR) MODULE
(FOR VEHICLE WITH AIR BAG SYSTEM)
WARNING:
When handling an air bag (inflator) module, be sure to
read SERVICE PRECAUTIONS in SECTION 10B and ob-
serve each instruction. Failure to follow them could
cause a damage to the air bag (inflator) module or result
in personal injury.
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to DISABLING AIR BAG SYS-
TEM under SERVICE PRECAUTIONS in SECTION 10B.
3) Loosen 2 bolts (1) mounting driver air bag (inflator) module on
its both side.
4) Remove driver air bag (inflator) module (3) from steering wheel.
5) Disconnect yellow connector (1) of driver air bag (inflator) mod-
ule and horn connector (2) in order a)–d) shown in the figure.
INSPECTION
WARNING:
Never disassemble driver air bag (inflator) module or
measure its resistance. Otherwise, personal injury may
result.
CAUTION:
If air bag (inflator) module was dropped from a height of
90 cm (3 ft) or more, it should be replaced.
Check air bag (inflator) module visually and if any of the following
is found, replace it with a new one.
Air bag being deployed
Trim cover (pad surface) (1) being cracked
Wire harness or connector (2) being damaged
Air bag (inflator) module being damaged or having been ex-
posed to strong impact (dropped)