Table of Contents
Advertisement
Figure 31
1. Windshield support
2. Hex-flange bolt (5/16 x 1
inch)
4.
Secure the lower bracket of the left and right
windshield supports to the machine using 4
carriage bolts (5/16 x 1 inch) and 4 flange nuts
(5/16 inch) in the holes you drilled in step
(Figure
32).
Figure 32
1. Carriage bolt (5/16 x 1
inch)
2. Flange nut (5/16 inch)
5.
Use 2 carriage bolts (5/16 x 2-3/4 inches) and
2 flange nuts (5/16 inch) to secure the rear
canopy support and the rear screen to the roll
bar
(Figure
33).
g214689
3. Nut—inside dash frame
(5/16 inch)
1
g036554
3. Lower bracket of
windshield support
1. Carriage bolt (5/16 x 2-3/4
inches)
2. Flange nut (5/16 inch)
6.
Use 4 carriage bolts (5/16 x 2-3/4 inches) and
4 nuts (5/16 inch) to secure the rear mount
brackets and the rear corner gussets to the roll
bar
(Figure
34).
1. Rear corner gusset
2. Rear mount bracket
7.
Install 2 carriage bolts (5/16 x 2-3/4 inches) and
2 nuts (5/16 inch) to secure the rear screen to
the roll bar
(Figure
16
Figure 33
3. Rear screen
4. Rear canopy support
Figure 34
3. Carriage bolt (5/16 x 2-3/4
inches)
4. Flange nut (5/16 inch)
34)
g214618
g231406
Advertisement
Table of Contents
