Troubleshooting - Bosch MFW35 Series Instruction Manual

Troubleshooting

Problem
The appliance does not
start when switched on.
The appliance is running
normally, but the food is
not being processed.
The food is not being
processed or only very
slowly.
The reversing function
does not start.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
MFW3_EU_8001019358.indb 27
Cause
Appliance has no power
supply.
The appliance was
overloaded, and the
agitator paddle has broken
at the predetermined
breaking point.
The attachment or worm
gear is blocked.
The pressure on the
pusher is too great or the
feed chute is too full.
The food to be processed
still contains hard
components.
The rev button was
pressed before the
appliance had stopped
completely.
The worm gear is blocked
right up.
Troubleshooting
Remedy
Insert the mains plug in the
socket.
Switch the appliance off and
wait until it has stopped. Unplug
the appliance, remove the
attachment, take it apart and
clean. Replace the agitator
paddle. X "Overload protection"
see page 20
Appliance without reversing
function: Switch appliance
off, wait until it has stopped
and unplug. Remove the
attachment, take it apart and
clean to eliminate the blockage.
X "Care and daily cleaning" see
page 23
Appliance with reversing
function: Switch appliance off
and wait until it has stopped.
Press the rev button briefly to
eliminate the blockage. Then
switch back on again and
continue work. X "Reversing
function" see page 20
Reduce the pressure on the
pusher and fill the feed chute
with less food.
Remove hard components.
Precook/steam vegetables
before processing them.
Switch the appliance off and wait
until it has stopped. Only then
press the rev button.
Switch the appliance off, wait
until it has stopped and unplug.
Remove the attachment, take it
apart and clean to eliminate the
blockage. X "Care and daily
cleaning" see page 23
en
27
01.12.2015 12:05:49