Philips 9000 Series Manual page 16

16
English
Do not cleanse the sensitive area around your eyes.
7 After approx. 20 seconds, move the appliance to your other cheek
and start cleansing this part of your face (Fig. 38).
8 After approx. 20 seconds, move the appliance to your forehead
and start cleansing this part of your face. Gently move the brush
head from left to right (Fig. 39).
Note: We advise you to not overdo the cleansing and to not
cleanse any zone longer than 20 seconds.
9 After the treatment, rinse and dry your face (Fig. 40).Your face is
now ready for the next step of your daily skincare routine.
10 Clean the attachment after use (see 'Cleaning and maintenance').
Cleaning and maintenance
Note: The accessories supplied may vary for different products. The
box shows the accessories that have been supplied with your
product.
Cleaning the shaver in the SmartClean system
SmartClean system Plus has two phases: the rinsing phase and the
drying phase (Fig. 41).
Preparing the SmartClean system for use
Caution: Do not tilt the SmartClean system to prevent leakage (Fig.
42).
Note: Hold the SmartClean system while you prepare it for use.
Note: If you clean the shaver in the SmartClean system once a week,
the SmartClean cartridge lasts approximately three months.
1 Put the small plug in the back of the SmartClean system.
2 Put the supply unit in the wall socket.
3 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2) (Fig. 43).
4 Pull the seal off the cleaning cartridge (Fig. 44).
5 Place the cleaning cartridge in the SmartClean system (Fig. 45).
6 While holding the SmartClean system with one hand, gently push
the top part of the SmartClean system back down ('click') (Fig. 46).