Specifications; Attachments/Accessories; Before Operation; Before Operation Safety - Toro Groundsmaster 3500-D Operator's Manual

Specifications

Note:
Specifications and design are subject to
change without notice.
Traction Unit
Overall width: 68-inch width
of cut
Overall width: 72-inch width
of cut
Length
Height to top of the ROPS
Wheel base
Track width
Ground clearance
Weight of cutting units
Models 30807,
30839, and 30843
Model 30849
Cutting Deck
Length
Width
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
182 cm (71.8 inches)
193 cm (75.8 inches)
295 cm (116 inches)
180 cm (70.8 inches)
149 cm) (58.5 inches)
145 cm (57 inches)
15.3 cm (6 inches)
963 kg (2,124 lb)
952 kg (2,099 lb)
86.4 cm (34 inches)
86.4 cm (34 inches)
24.4 cm (9.6 inches)
to carrier mount
26.7 cm (10-1/2 inches)
at 3/4-inch height of cut
34.9 cm (13-3/4 inches) at
4-inch height of cut
88 kg (195 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
Know how to stop the machine and engine quickly.
•
Check that all safety devices are attached and
functioning properly. This includes, but is not
limited to, operator-presence controls; safety
switches and shields; the rollover protection
system (ROPS); attachments; and brakes. Do
not operate the machine unless all safety devices
are in position and functioning as intended by the
manufacturer.
•
Always inspect the machine to ensure that the
blades, blade bolts, and cutting assembly are not
worn or damaged. Replace worn or damaged
blades and bolts in sets to preserve balance.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
potentially throw.
•
Evaluate the terrain to determine the appropriate
equipment and any attachments or accessories
required to operate the machine properly and
safely.
23