Rack Mounting - Sony MAV-2000 Installation Manual

1-5. Rack Mounting

c
Install the unit in a stable location.
If the unit is mounted on a unstable table or slant bench,
the unit can fall and result in physical injury.
c
Use the specified support angle.
If the parts other than the specified one are used, the unit
can fall and results in physical injury.
This unit can be mounted in a 19-inch standard rack of EIA
standard. To mount the unit in the rack use the specified
support angle kits and parts.
n
Mount the unit in the rack with the HDD removed from the
unit.
Specified rack mount kit : RMM-2000 (option)
Constituent parts
. Outer Support Assembly
Outer Support
Bracket
Screw (B4 x 12)
Inner Support
. Plate Nut
. Screw (B4 x 12)
The following parts are supplied for rack mounting.
. Screw (RK5 x 14)
. Ornamental Washer
n
Standard Tightening Torque
Screw Size Standard Tightening Torque
M3.0 0.7 to 1.0 N.m (7 to 10 kgf.cm)
M4.0 1.2 to 1.6 N.m (12 to 16 kgf.cm)
MAV-2000
2 pcs
2 pcs
4 pcs
8 pcs
2 pcs
4 pcs
16 pcs
4 pcs
4 pcs
1. If there is any equipment with an HDD installed in the
rack and the main power on, turn off the main power.
2. Remove the four screws from the side of the unit, lift
up the unit and remove the four foot holder assemblies.
3. Remove the 10 screws on the side of the unit and
attach the inner support to the side of the unit using the
removed screws.
B4 x 8
1-5. Rack Mounting
B4 x 8
Foot holder
assembly
Inner supports
B4 x 8
1-7 (E)