5 Configuration and Settings
5.2 Network connections
No.
Enable the "Specify an IP address" checkbox
6.
and accept the displayed settings:
IP-Address: 192.168.0.2
Subnet Mask: 255.255.255.0
Finally, accept the settings made in the
"PN_X1" and transfer settings with "OK".
7.
The transfer mode in the start center has to be
enabled to subsequently transfer the HMI
project part into the Comfort Panel.
5.2
Network connections
The LAN network card of the programming device requires a static IP address to
configure the controller and the HMI and to configure the weighing module.
The following table describes the configuration of the LAN connection.
Table 5-2
No.
Select "Start > Control Panel > Network and
1.
Sharing Center > Change adapter settings"
to open the network connections.
Select your network connection.
Right-click to open the properties.
Weighing, Controlling and Logging (Set 6)
Entry ID: 82454336,
V2.0,
Action
Action
10/2017
Comment
Comment
36