Data Setting Screens (Cont'd)
the following screens show the procedure for setting the data variables. they are accessed from the main
Data Setting screens (see
DeFaUlt SettingS
pUSh: SeleCt
DeFaUlt SettingS
pUSh: SeleCt
loops through both
possibilities
bUZZer VolUme: 2
to aCCept: Set
bUZZer VolUme: 0
to aCCept: Set
bUZZer VolUme: 1
to aCCept: Set
loops through three
possibilities
lCD Sleep: 3 min
to aCCept: Set
lCD Sleep: 30 min
to aCCept: Set
loops through both
possibilities
aUto rUn: yeS
to aCCept: Set
aUto rUn: no
to aCCept: Set
loops through both
possibilities
34
page
33) when the SHIFT/SELECT key is pressed:
Shift
Set
+
Select
monitor
Shift
Set
+
Select
monitor
returns to Data Setting screens
Shift
Set
+
Select
monitor
Shift
Set
+
Select
monitor
Shift
Set
+
monitor
Select
returns to Data Setting screens
Shift
Set
+
Select
monitor
Shift
Set
+
Select
monitor
returns to Data Setting screens
Shift
Set
+
Select
monitor
Shift
Set
+
Select
monitor
returns to Data Setting screens
Key lock function: allows the operator
Key loCK: DiS
to disable the RUN + STOP button
to Change: SeleCt
functions. when this function is set to
EN the unit will remain in the operating
mode it was in when enabled and
Key loCK: en
will not be able to be changed with
to Change: SeleCt
the RUN + STOP buttons until this
function is disabled. with this function
(with new value applied)
set to DIS, the RUN + STOP buttons
function normally.
Default setting is DIS.
buzzer:
bUZZer VolUme: 2
2 = high
to Change: SeleCt
1 = low
0 = off
bUZZer VolUme: 0
Default setting is 2 = high (loudest)
to Change: SeleCt
bUZZer VolUme: 1
to Change: SeleCt
(with new value applied)
lCD Sleep: Displays the number of
lCD Sleep: 3 min
minutes (3 or 30) of idle time before
to Change: SeleCt
the lCD will go blank (this is to prolong
lCD life). the lCD will be active again
once a display button is pressed.
lCD Sleep: 30 min
to Change: SeleCt
Default setting is 3 min.
(with new value applied)
auto run: if set to YES, the unit will
aUto rUn: yeS
automatically start up in the UpS
to Change: SeleCt
mode (on line) when input voltage is
applied, regardless of what mode it
was in when shut down.
aUto rUn: no
to Change: SeleCt
Default setting is NO.
(with new value applied)
1600ep Series instruction manual