Table of Contents
Advertisement
6-15 Ram Position
A. Ram can be moved by loosening three ram lock studs on turret and moving to
desired position.
CARE SHOULD BE TAKEN TO LOCK RAM SECURELY
It is recommended that on heavy milling work, head should
be kept as close to column as possible, where maximum
B. Swiveling Turret and Moving Ram on 6VK
SWIVELING TURRET:
1.
2.
3.
MOVING RAM:
1.
2.
3.
6-16 Clamping Table, Saddle and K nee:
When milling with longitudinal table feed only it is advisable to clamp the knee to
the column and the saddle to the knee to add rigidity to these members and provide
AFTER SETTING.
rigidity is obtained.
USE SPANNER
LOCKING BOLTS
ROTATE TO THE REQUIRED ANGLE SETTING
LOCK THE FOUR BOLTS
USE SPANNER
TURN THE ADJUSTMENT BOLT TO MOVE THE RAM TO
THE REQUIRED POSITION .
LOCK AND TIGHTEN THE REAR BOLT FIRST , THEN THE
FRONT ONE.
CAUTION
NOTE
TO UNLOCK THE FOUR
WRENCH
.
.
TO UNLOCK THE TWO BOLTS .
WRENCH
- 98 -
.
Advertisement
Table of Contents
