Installation - Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual

Modular RAID 6Gb/s (SAS2.0)
Connectors
Connector Type
SAS0 x1 SAS0
SAS1 x1 SAS1
SDB SAS side band
signals
BBU
Indicators
LED Description
HB Heart Beat
WP Write in cache pending
WA Warning
4.3.4

Installation

This section describes how to install the SAS RAID controller in a server.
V
CAUTION!
To safeguard against data loss, remember to back up your data before
you change your system configuration.
To install the new controller, proceed as follows:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove
it from the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu
support service.
Step 2 Prepare the server
Shut down and power off the server and remove the server blade
from the chassis.
50
Description
SATA connectors to connect local
SAS/SATA hard disk drives
SATA connectors to connect local
SAS/SATA hard disk drives
6-pin connector
SAS side band connector
Connector for direct iBBU connection
Modular RAID Controllers