1
Removing the Machine from
the Shipping Container
Model No. 31902 Only
No Parts Required
Procedure
1.
Remove the screws that hold down the rear
wheel hubs to the pallet.
2.
Cut the cable tie that holds the driveshaft to the
rear tires.
3.
Remove the rear wheels from the shipping skid.
4.
Raise the roll bar; refer to
(page
27).
5.
Connect a hoist to the top, center area of the roll
bar and raise the machine.
6.
Remove the shipping skid from the bottom area
of the machine.
7.
Position 2 jack stands under the rear area of
the machine shown in
Machine (page
41).
8.
Lower the machine on the jack stands.
2
Installing the Rear Tires
Model No. 31902 Only
Parts needed for this procedure:
2
Rear wheel
8
Lug nut
Procedure
1.
Use 4 lug nuts to secure the wheel to the wheel
hub
(Figure
3).
Raising the Roll Bar
Raising the Rear of the
1. Wheel hub
2. Tire
2.
Torque the wheel lug nuts; refer to
Wheel-Lug Nuts (page
3
Removing the Front Tires
Model No. 31902 Only
No Parts Required
Procedure
Note:
You must perform this procedure to correctly
install the lift arms.
1.
Place jack stands under the front side-frame
tubes to raise the front wheels; refer to
the Front of the Machine (page
2.
Loosen and remove the wheel lug nuts
11).
11
Figure 3
3. Lug nut
Torquing the
52).
Raising
40).
g299549
(Figure