Table of Contents
Advertisement
2.1.35 Transport driven roller 2 (Spine bending roller 2/3
unit) (15 million sheets)
1) Open the transport roller 2/3 unit [1].
2) Remove the harness protection cover [1].
- Screw [2]
3) Remove the two connectors [1], and then release the harness from the two
edge saddles [2].
[1]
F-2-78
[2]
[1]
F-2-79
[1]
[2]
F-2-80
4) Remove the transport roller unit 2/3 [1].
- 4 screws [2]
0024-6854
[2]
CAUTION:
Install the spine bending unit so the locking arm [3] on the back of the
transport roller 2/3 unit will fit into the hole [4] in the spine bending unit. If
you have difficulty precisely locating the spine bending unit, turn the spine
bending drive pulley [5] by a hand to move the spine bending unit.
[1]
F-2-81
[3]
[5]
[4]
F-2-82
Chapter 2
[2]
2-19
Advertisement
Table of Contents
