Table of Contents
Advertisement
Number
Item
3
Speaker Wires – These connections correspond to P6 detailed in
Cable Pin Diagram on page 114
eCH. The Audio Amplifier which supplies this output requires an independent DC Sup-
ply, refer to
installation of the associated Loudspeakers such as RSN4002_.
4
Free-end Wires – If used during installation, heat-shrink wrap unused wires to prevent
shorting. These connections correspond to P3 detailed in
Pin Diagram on page
Hands Free Microphone (HF1 and HF2) these two inputs are individually screened
and include a common drain-Ground, PTT1 and PTT2, Power On, Rear Audio and the
available GPIO lines. The use of Impres Visor Microphone RMN5054_ also requires
the One Wire bus connection provided on this cable.
5
Rear GCAI Connector – These connections correspond to P2 detailed in
RECH Y-Cable Pin Diagram on page 114
cessory connector which enables compatible Accessories such as the RMN5107_ Fist
Microphone to be connected to the rear of the Control Head.
6
Ferrite Clamp, PN 91012044002. Manual installation is required. Clamps are installed
with 2-turns of wire around the clamp.
7
Ferrite Clamp, PN 91012044003. Manual installation is required. Clamps are installed
with 2-turns of wire around the clamp.
8
Fuse of 2A, PN 65012023001
9
Label for Y-cable power rating
NOTICE:
See
Chapter 5
for wiring and pin out information.
Manual installation required. Clamps are fixed with 2-turns of wire.
The Accessories Expansion TSCH Y-Cable (PMKN4134_) allows the user to connect extra
accessories.
Send Feedback
and correspond to the Loudspeaker output of the
Number
2. The use of connector kit PMLN6487_ allows a plug and play
114. These connections provide multiple functions including
Chapter 4: Radio Installation
Figure 71: RECH Y-
Figure 71: RECH Y-Cable
and this is the Ten (10) pin Rear GCAI Ac-
68015000181-LB
Figure 71:
65
Advertisement
Table of Contents
